Aluminum Aerial anchoring clamps

 The “FO-DN54” cable anchor clamp are made up of the following components:

• The body of the clamp, made of aluminium with a high resistance against corrosion and the main mechanical base support.

• The tapered fastening system is manufactured from synthetic material with the aim of doubly isolating the conductor and avoiding the deterioration of the isolating jacket.

• The anchoring system comprises of a stainless steel cable that includes a synthetic material cable protector.

Use:

For anchoring low voltage braided aerial networks with a neutral isolated stiffener strung over supports or outdoor walls.

The main features, type testing, acceptation and qualifying procedures correspond with Normative: EN 50483-3.

Comes in 50 unit packs.

Installing:

For the correct installing of the “DN” cable anchor clamp "DN", the following steps are recommended:

• Loosen one of the studs on one side of the cable anchor.
• Place the cable into the support or fixing point and then fasten it to the body of the clamp.
• Separate the cable stiffener from the rest of the conductors that make up the cable.
• Shift the wedges to completely open it up and then put the stiffener into it.

Proceed to tauten the cable and once done shift the wedges until it is held tight.